Sonnox Fraunhofer Pro-Codec Manual de usuario descargar pdf (Pagina 49)

5.10 DescriptionofControls 5 THE PRO-CODEC PLUG-IN

Dither

Only visible if the selected codec is HD-AAC. Only enable 16 or 24 bit dither if the

input to the plug-in has not already been dithered and truncated to either 16 or 24

bits.

Downmixingmode

Only visible if the selected codec is AAC-LC MPS or HE-AAC MPS. This allows you

to audition the various Fraunhofer downmixing algorithms. By default, no

downmixing takes place.

Note:

When auditioning a 2-channel downmixing mode, the DIFF signal will contain

content from the centre, surround and LFE channels, since the DIFF calculation

is done using the input and encoded signals.

OutputSection

Output Section

MONITOR

Indicates the plug-in’s audio output;

either INPUT (ie. the plug-in is bypassed) or CODEC. You can

switch between input and codec output by clicking on the LEDs.

A special case for the mp3-HD codec, whereby the MONITOR

signal is synthesized, is denoted by an INPUT 16 indication.

TOTAL DELAY

This window shows the total delay through the plug-in; click to

toggle between samples or milliseconds. The ﬁgure given is the

maximum of each individual codec delay. This ﬁeld is updated

in the GUI immediately a new codec or other setting is selected.

Depending on the host behaviour, the new value may not

be available for delay compensation until the plug-in is removed

and re-instantiated.

RECORD

Writes the active codecs pre-selected for record-arm to disk.

FilenameFormat

This button calls up a pop-up used to conﬁgure the encoded ﬁle data.

www.sonnox.com 49 Gotocontents

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 88 89

Sin comentarios

Sonnox Fraunhofer Pro-Codec Manual de usuario Pagina 49