Sonnox Restore Manual de usuario descargar pdf (Pagina 8)

“Smooth” - Adjusts the peakiness of the noise profile.

“Tune” – In some situations can help to remove musical noise.

“Auto” Mode - Enables automatic updating of noise profile and the noise profile level relative

to the input signal.

“Freeze” Mode – Once you have obtained a good profile, this button will freeze the profile to

prevent it updating.

“Manual” Mode – In this mode, the profile is forced flat to represent white noise. You can then

use the “Colour”, “Air” and bias controls to modify the shape of the profile.

“Colour” – Modifies the LF shape of the noise profile.

“Air” – Modifies the HF shape of the noise profile.

Description of Controls – DeNoiser Removal Section

“Reduction” – sets the amount of attenuation of broadband noise components below the

threshold.

“HF Cut” – This is a simple low-pass filter with a fixed -18dB attenuation. It is active when the

DeNoiser Enable and Master Enable are both active.

“Makeup” – Provides a way to adjust the level of the de-noised signal to compensate for any

loss in level due to the de-noising process. This makes it easier to perform with and without de-

noising comparisons using the master IN button.

“Enable” – If Master Enable is also IN, this makes the broadband DeNoiser active using

glitchless switching.

Description of Controls – Display

“Bias Select” – This toggles between the red bias curve that modifies the shape of the noise

threshold profile, and the yellow bias curve that modifies the shape of the noise reduction.

1 2 3 4 5 6 7 8 9 10

Sin comentarios

Sonnox Restore Manual de usuario Pagina 8